LayBrick Stone Filament 3 mm, 250 g

You get 250 g in 2.85 mm diameter as a coil out of LayBrick filament beta..

LayBrick is printable from smooth to very rough surface, near sandstone

LayBrick feels like stone and is just great for architecture models and landscapes
Printed objects can also be colored and easely grinded.

• for architecture models / landscapes
• no plastic feeling
• ideal for jumbo-printers / please read advise below about beta!
• the objects are ink-able, grind-able
• no heated bed necessary
• contains natural mineralic fillers (super-fine milled chalk) and harmless co-polyesters
• the printed object is temperature stabil to about 70° Celsius

beta version of this filament: means that the grey colour of the filament may change in nuances, the filament is also a little maiden, it may brake while bending, you should be sure (especially during a long print) that you can feed a broken part of filament again in your printer !

use M227 code: f.e. S 30000 P 10000
you may print layer-thickness from 0.1 mm to 0.5 mm
slicing: object fill max. 25%,
fan needs to be on !!!
wait after printing until object is hardened, then remove it from platform (2-4 hours)

LayBrick has nearly no warpeffect ! (0,5/10)

This filament is primarily used for 3D Printer and Rapid Prototyper.

Please note, that some filaments may break when they are bent in a small radius. A warm environmental condition will reduce the risk of brittleness.